19
If you do not see the indications stated above, place the power switch to the off
position and remove the 120 VAC power by placing the breaker in the off
position. Contact you Brasch distributor, or the Brasch factory, for
instructions on how to proceed.
3-3
Initial Displays
3-3.1
Immediately after applying power, the panel power indicator will be glowing and
the LCD will display the following message.
After about 10 seconds, the panel will enter its startup ventilation mode. If any
ventilation zones are programmed to be on, they will actuate at this time. The
zone indicators associated with those zones will then glow. The panel will
remain in the startup mode for approximately 2 ½ minutes. After this time is
completed, the panel will enter the measure mode. The display will then change
to the following.
The display updates about every five seconds. If there are any failed
transmitters, the display will then indicate the following.
Press the “MENU” key and the display will then change to the following:
Press the “NEXT” key and the display will change to:
DATE (DOW) (CURRENT DATE)
TIME (HOURS:MINUTES)
WARMING UP
PLEASE WAIT
DATE (DOW) (CURRENT DATE)
TIME (HOURS:MINUTES)
PRESS MENU KEY
FOR OPTIONS
DATE (DOW) (CURRENT DATE)
TIME (HOURS:MINUTES)
FAILED SENSOR
CHECK SYSTEM STATUS
PROGRAM SYSTEM
ENT/PREV/NXT
Содержание GDCP-A
Страница 17: ......
