Branson Krautkramer MIC 10, Руководство пользователя

Страница: 27 / 146

0
Note:
If the instrument is not going to be used for a long
period, remove the batteries from the compartment!
When the battery voltage is too low a symbol will ap-
pear on the MIC 10 display:
If this symbol appears, the batteries must be immedi-
ately changed. The MIC 10 automatically switches off
if the batteries are too low in order to guarantee re-
liable measurement.
When measurements are made at remote locations a
spare set of batteries should be present.
Further information with regard to batteries and accu-
mulators can be found in Chapter 8.1.
0
Note:
Used or defective batteries are special refuse and
must be disposed of according to the governing laws!
3.2 Connection of hand-held probes
In order to prepare the MIC 10 for operation, the probe
must be connected. The probes available for the
MIC 10 are: MIC 201-A (1 kgf), MIC 205-A (5 kgf) and
MIC 2010-A (10 kgf).
–
Connect the probe to the probe cable. The red mark-
ing points at probe socket and cable connector
must be on top of each other.
–
Connect the probe cable to the MIC 10 socket.
–
Place the probe grip onto the probe.
–
Screw on the conical probe attachment for short
measurements (refer to Chapter 2.2
Required ac-
cessories ).
socket for
probe connection
Connection of hand-held probes
Preparations for operation
Krautkrämer MIC 10 Issue 08, 08/01 3-3
0
Note:
If the instrument is not going to be used for a long
period, remove the batteries from the compartment!
When the battery voltage is too low a symbol will ap-
pear on the MIC 10 display:
If this symbol appears, the batteries must be immedi-
ately changed. The MIC 10 automatically switches off
if the batteries are too low in order to guarantee re-
liable measurement.
When measurements are made at remote locations a
spare set of batteries should be present.
Further information with regard to batteries and accu-
mulators can be found in Chapter 8.1.
0
Note:
Used or defective batteries are special refuse and
must be disposed of according to the governing laws!
3.2 Connection of hand-held probes
In order to prepare the MIC 10 for operation, the probe
must be connected. The probes available for the
MIC 10 are: MIC 201-A (1 kgf), MIC 205-A (5 kgf) and
MIC 2010-A (10 kgf).
–
Connect the probe to the probe cable. The red mark-
ing points at probe socket and cable connector
must be on top of each other.
–
Connect the probe cable to the MIC 10 socket.
–
Place the probe grip onto the probe.
–
Screw on the conical probe attachment for short
measurements (refer to Chapter 2.2
Required ac-
cessories ).
socket for
probe connection
Connection of hand-held probes
Preparations for operation
Krautkrämer MIC 10 Issue 08, 08/01 3-3