Brandt VF 300 Series, Руководство по эксплуатации

Страница: 22 / 27

43
42
- Adjust the adjustable
feet
- Adjust the rear feet
- Take off the door seal
all around the door.
- Check that the seal is pre-
sent and re-tighten the nut
- Close the water tap and
call an engineer.
- Recentre the door by
adjusting the rear feet.
- Contact the installer.
- Pull the machine out
10cm and tighten the 2
tensioning screws.
- Contact the installer.
- Pull the machine out
10cm and tighten the 2
tensioning screws.
- Fit a wooden panel to the
door (a chipboard panel OK
if on a temporary basis)
and adjust the springs.
- Contact the installer.
- Move the basket gradu-
ally on one side and
then the other (until
you hear a “Click”) = ->
see the Operating Instructions.
- Use these programmes
preferably at night
when the length and
the finishing time are
not important.
- The machine is wobbly,
not level
- The door is not correct-
ly centred on the tub
- The seal’s lip has been
flattened during storage
.
- Leak at the tap
- Leak in the machine
- The machine or the
door is not correctly
centred
- The door springs are
not tensioned enough
to compensate for the
weight of the basket.
- The door springs are
over-tensioned.
- No wooden panel
- Poor handling (the bas-
ket has been pulled
upwards too quickly).
- The energy-saving pro-
grammes take longer
because they compensate
for the lower washing and
drying temperatures by
longer washing and drying.
Small door leak
Small leak around or
under the machine (move
the machine to locate the
leak better)
The door “catches” when
you close it
The door falls down
heavily when you open it
(integrated models)
The door is not level
when open or goes back
up too quickly (integrated
machine)
The upper basket will not
stay in the high position
The cycle takes too long.
Troubleshooting, what to do?
If you are in any doubt about the operation of your machine, before calling a qual-
ified engineer, check the following points (depending on the symptoms noticed).
When first using the machine Possible causes What to do
Programming, display anomalies Possible causes What to do
Protecting the environment
Recycling the packaging
Recovering and reprocessing
packaging material saves on
material and reduces the amount
of waste.
Take your packaging to the near-
est recycling centre. Contact your
town’s local authorities for
details of its location.
Recycling your old
dishwasher
If you wish to dispose of your old
dishwasher, make it completely
unusable. Break the door lock so
that it cannot close (children can
become locked in when playing
inside the machine – risk of suffo-
cation).
Remove the electrical plug and
cut off the power cable.
Take your unusable machine to
the nearest recycling centre.
Contact your town’s local authori-
ties for details of its location.
Warning: Keep all the
packaging materials out of children’s
reach (e.g. plastic bags, polystyre-
ne, etc.): these can be dangerous
for children: risk of suffocation).
Washing economically and
ecologically
DO not wash the items first by
hand (unnecessary waste of
water). Use your dishwasher’s
capacity to the full. You will then
wash economically and ecological-
ly.
Always select a washing pro-
gramme suitable for the type of
items and how dirty they are.
Do not overdose with detergent,
regenerating salt or rinse aid.
Follow the recommendations in
these instructions (Pages 30 - 32
- 33) and the manufacturer’s
instructions on the pack.
Ensure that the water softener is
set correctly (see Page 30)