1.
Ensure control knob on heater is in the
OFF position.
2.
Open valve for fuel supply.
3.
Turn control knob to position.
Press igniter button multiple times to light burner. When
burner is lit, continue to press and
hold down control knob for 30 seconds. This engages the
thermocouple.
If burner does not light, release control knob and turn it clockwise to the OFF
position. Wait 5
minutes. Repeat steps 2 to 3.
4.
If igniter does not work properly, you may light heater manually by inserting a match through
the opening at base of burner (6), as shown in figure 1.
5.
Turn control knob counter clockwise to adjust flame to desired temperature for comfort
Operating The Heater
To Turn Off
1.
Turn control knob fully clockwise.
2.
Tu
rn off gas supply at source.
3.
If heater is not used for long periods, remove from gas
source.
Preventative Care and Maintenance
To ensure long-lasting enjoyment of your Patio Heater, the burner should be inspected
regularly for debris such as insects and spider webs.
Have
Heater Inspected If
-Y
ou smell gas combined with yellow flame tips on burne
r
-H
eater does not provide expected heat capacity
-A
bnormal sounds occur during operation
Also...
-Periodically check for leaks in the system or immediately when you smell gas.
-In case a leak is detected, extinguish all open flames in the area.
-Never leak test while smoking or with an open flame.
-If you cannot repair a leak, ensure gas supply is turned OFF
a
nd
contact the retailer
where
you
purchased the heater, a qualified technician, or your gas supplier.
-Do not modify this heater in any way.
-Replacement parts must only be with original parts.
-The installation of this appliance should be performed by a certified gas technician in
conformity
with all building and municipal codes.
10