Terminal Block
display screen examples:
Display screen before text/zones
entered
Display screen showing 12-zone label
with the first of 12 zones displayed
66-Block Labels
Note:
See
DataComm & T-Block Menu Selections
for a list of the high-level DataComm
& T-Block Menu selections, their default values, and the corresponding softkeys.
This example outlines the functionality required to create a 66-Block label using the DataComm &
T-Block menu. This example also assumes the use of a dedicated 66-Block label part (width = .375").
To create a 66-Block label:
Step 1.
Insert a dedicated part (XC-375-498). The printer reads the smart-cell settings and
automatically displays the screen allowing you to choose between the General ID Menu
and DataComm & T-Block Menu. Upon selecting the DataComm & T-Block Menu, the
following datacomm menu options appear above the softkeys:
P-PNL, T-BLK, DESI, 110BLK, 66BLK, BIX.
Note:
To escape to the
General ID Menu
screen press
FUNCTION
+
CLEAR/ESC
.
Step 2.
Press
NEXT
, then the
66-BLK
softkey. The default
66-Block
information automatically
appears on the display screen as shown below (in inches or millimeters, depending on user
settings*):
*See
Setting Units
on page
36
for instruction on setting
units to inches or millimeters.
Step 3.
To set or accept the length, do one of the following:
•
Press the
ENTER
key to accept the default, or
•
Press the
LEN
softkey, enter a new width, and press
ENTER
.
Note:
From this point, similar functionality is used as when working with Patch Panels.
See
Patch Panel Labels
on page
23
for more information.
26
User Manual