9
Express® Lavatory System SS-Series
Installation - Obsolete
SS-3/BIR/WH97TAS
Bradley Corporation • 215-1469 Rev. B; EN 08-805
4/24/08
WASHER
COVER SCREWS (4)
FLEX
HOSE
FILTER
Figure 6b
Figure 6a
Installation Instructions continued . . .
Step 3: Install bowl assembly (continued)
4. Remove the battery boxes from the bracket. Remove the four phillips head screws from the
operation box cover (see Figure 6a). Install six "AA" alkaline batteries (not included) into
each battery box and reattach the cover. Wait for five seconds before testing the unit (this will
allow sensors to adapt to site conditions).
5. HOT/COLD VERNATHERM™ OPTION ONLY: Attach the 1/2" cross to the
Vernatherm™ assembly using a thread sealer (see Figure 4 on page 7).
6. Attach the male end of the 1/2" flexible hose to the 1/2" cross using a thread sealer. Attach
the female end of the 1/2" flexible hose to the battery box using the fiber washer attached to
the hose (see Figure 4 on page 7).
7. Attach the 1/4" supply tubes from the sprayhead to the battery box’s 1/4" connector fitting.
Make sure the black color supply tube goes to the left side battery box, the green tube goes
to the center box and the red tube goes to the right side box (see Figure 4 on page 7).
IMPORTANT: When bolting the bowl assembly to the frame and wall, do not
overtighten the bolts. Overtightening bolts can damage the Terreon® material.
8. After the bowl assembly is attached to the frame, use two 3/8" bolts and washers (supplied
by the installer) to bolt the bowl to the wall anchors.
9. Tighten the screws installed to secure the bowl assembly to the frame.
Do not overtighten.
