S59-1005SR
Installation
2
1/8/2020
Bradley
• 215-1674 Rev. F: ECO 19-03-024
Safety Information
To ensure proper operation:
Installation
Failure to comply with proper installation and maintenance instructions could contribute to a valve failure resulting in severe bodily
injury including scalding, chilling, and/or death depending upon system water pressure changes and/or supply water temperature
changes .
Hot limit screw is set in the maximum temperature position . Failure to properly adjust may result in serious scalding . This valve
may not protect from scalding if there is a failure of other temperature-controlling devices elsewhere in the plumbing system .
Excessive heat may cause damage to internal parts .
This valve is intended to be installed as an ASSE 1016 valve- at the point of use, where the user has access to flow or final
temperature controls . This valve should not be used where an ASSE 1017, ASSE 1069, or ASSE 1070 device is required .
Make sure that all water supply lines have been flushed and are then completely turned off before beginning installation . Debris in
supply lines can cause valves to malfunction .
Installation of this system must be completed by a qualified plumber in compliance with all national and local codes . Compliance
and conformity to local codes and ordinances is the responsibility of the installer . Should these codes differ from the information in
the manual, follow the local codes . Inquire with governing authorities for additional local requirements .
Inspection
Regular checking and cleaning of the valve's internal components and check stops is necessary for maximum life and proper
product function . Periodic inspection and yearly maintenance by a licensed contractor is required . Corrosive water conditions
and/or unauthorized adjustments or repairs could render the valve ineffective for its intended service . Frequency of cleaning and
inspection depends upon local water conditions .
Supplies Required:
• Teflon Tape
• Allen key wrenches
• Screwdriver
• 1/2" NPT Brass pipe plug
• Adjustable wrench
• 100% Silicone Sealant
• Semi-Permanent Threadlocker
• Security sealant (if required)
• Silicone Grease (supplied)
