without a connector, by passing them directly through
the corresponding holes in the seat.
(17)
Harness
strap
connector.
17
fig. 3
(5)
Harness
adjustment
button.
5
fig. 2
• The buckle clasps come together without making a
click.
• It becomes difficult to insert the clasps into the
buckle (resistance is felt).
• The buckle only opens when forced.
3.3. Solution
Clean the harness buckle so that it works properly.
3.4. Cleaning the harness buckle
1. open the buckle (press the red button).
2. Hold the metal plate
(19)
from below in a vertical
position.
3. Slide the metal plate
(19)
along the slot.
4. Remove the buckle
(4)
.
5. Steep the buckle
(4)
in hot water and neutral liquid
detergent for at least one hour. Rinse and dry it.
3.5. Removing the 5-point harness
1. Loosen the harness straps by pulling them at the
point where they cover the chest while pressing
the harness adjustment button
(5)
(fig.2).
2. Locate the harness strap connector
(17)
and
unclip the harness straps, freeing them from the
connector, then remove them by pulling them
from the front of the seat (fig. 3).
3. Free the shoulder protectors
(3)
by unfastening
them from the connector that joins them (located at
the back of the seat) or, in the event they are joined
arm that regulates the harness height must
be removed
(20)
.
4. Turn the seat over and, from the back, free the belt
buckle
(4)
by passing the retention plate through
the slot in the seat (fig.4).
5. Remove the belt buckle and save it in the storage
bag.
6. Lift the fabric seat cover and pass the shoulder
straps
(9)
through the holes in the cover without
removing them completely. Keep them folded
between the cover and the seat (fig. 5).
7. Put the seat cover back on.
3.6. Removing the harness height adjuster arm
in order to extend the headrest height to the
maximum and use the seat as a group 2/3 seat the
fig. 4
19
(19)
Belt buckle
retention
plate.
fig. 5
fig. 6
(20)
Harness
height
adjuster
arm.
20
40
41
