BQS BM01, Инструкция по эксплуатации

Страница: 15 / 25

5. ADJUSTING CHILD SEAT.
Fastening & Unfastening the harness
1. Join the 2 buckle metal connectors, pass both
connectors through the slot in the upper part of
the buckle until you hear a “
click
” (5.1).
2. To unfasten the harness press the red button on
the buckle downwards (5.2).
Loosening the harness
3. Release the buckle by sliding the red F button
downwards and at the same time pulling out the
harness (5.3).
Tightening the harness
4. Pull the harness straps up to remove the slack
from the lap section of the harness, then pull the
harness regulating strap until the harness is fully
stretched (5.4).
5.
The harness should be as tight as possible without
causing discomfort to your child.
6. Make sure the lap section of the harness is
positioned as low as possible, surrounding your
child’s hips and not his stomach.
IMPORTANT
Ensure that the belt has no slack.
5. Pass the seat belt through R guides behind the
seat and make sure the diagonal belt is passed
through the O guide at the top rear of the seat (4.4,
4.5, 4.6 and 5.7).
6.
Insert the vehicle safety belt in the vehicle anchor
point. You will hear a “ click ” when properly installed
(4.8) .
7. A harness that is not properly tightened can be
dangerous. Check the harness adjustment and
tighten whenever you put your child in the child
safety seat.
Changing the harness height
8. Place the child on the seat (5.5).
9. Check the height of the shoulder straps for correct
position, the shoulders straps must be thread
through the slots in the cover and seat shell that are
closest to the top of your child´s shoulders (5.6).
10. Adjust the height of the harness, by pressing the
harness adjustment button and pulling the harness
straps towards you to loosen them (5.3).
11. Then unhook one of the harness connector straps
at the back of the seat and pull the loose strap
towards the front of the seat (5.7).
12. Insert the harness strap into the J slot of the fabric
and backrest at the front of the seat. Then insert
the harness strap into the appropriate upper or
lower slot at the rear of the seat (5.8).
13. Reinsert the harness strap in the harness
connector on the back of the seat (5.7).Then, do
the same with the other harness strap.
IMPORTANTE
Ensure that the belt has no slack.
28 BM01
Child restraint system
29
www.babyqs.com
Group 0/1
EN