BPC HP-206P, Руководство пользователя

Страница: 14 / 37

8
Submenu item Function
5 SIMULATION OFF
The purpose of this submenu to check dry contact connections. Normally to
check line failure contact you must turn off mains power. This is not
necessary with this utility. 3 options are available.
SIMULATION OFF simulation mode is off
SIM:LINE FAILURE if you press ENTER key for 3 seconds the line failure
lamp on interface board is turned on.
SIM:LIN.F+BT.LOW if you press enter key for 3 seconds the line failure and
battery low lamps on interface are turned on.
SIM:BYPASS if you press ENTER key for 3 seconds the bypass (aux) lamp
on interface board is turned on.
So you can check dry contact connections
6 ENTER FAULT RESET Faults reset selection.
7 ENTER EXIT
→
Enter (
↵
↵↵
↵
) exit from submenu
Goto first submenu item
2.2.3 MEASURES Menu items
All the measurements of the UPS can be monitored via this menu, navigation through the items is performed
using up and down buttons.
Submenu item Function
1 LD%: 060 Output load percentage
2 OP CURR : 011A Output current
3 OPV: 236 Output voltage
4 IPV: 400 400 400 3 Phase input voltages
5 BATT: 340 V Battery voltage
6 BYP: 230 By-pass voltage
7 FREQU: 50.0 Hz 50.0 Hz Input frequency – Output frequency
8 TEMP: 030 c UPS Internal temperature
9 ENTER EXIT
→
Enter (
↵ ↵↵ ↵
) exit from submenu
Goto first submenu item
2.2.4 ALARMS Menu items
The last 64 events can be monitored in this menu.
Submenu item Function
1 UPS STATUS Alarm status at that instant.
2 000>311201 23:15
Monitoring past alarms:
First 3 digit number indicates the event number, 000 event is the last one.
Date is in ddmmyy and time is in hh:mm format.
On the second line, the alarm events on the first line are listed. Using
↔
button 128 events can be viewed.
3 PARR.ERR.NR : 017
Parallel controller board error (If parallel hardware exists)
If this value is 0 then the parallel is OK
4 ENTER EXIT
→
Enter (
↵
↵↵
↵
) exit from submenu
Goto first submenu item