Bowflex TreadClimber TC5300, Руководство по обслуживанию

Страница: 29 / 52

Bowflex
®
TreadClimber
®
Service Manual
11.0 - REPLACEMENT oF vIRTuAL PIvoT ASSEMBLY
Tools Needed:
• Phillips and Flathead Screwdriver
• 1/2 inch Wrench
• 3/16 Allen Wrench
• (2) 9/16 inch Wrench
NOTE: If using a powered driver, it must be on the
“LOW TORQUE” setting, otherwise it will strip
screws.
11-1 Unplug machine from wall outlet.
11-2 Wait 5-minutes after unplugging machine to ensure
there is no residual power.
11-3 Remove rear step plastic (8 screws), right and left
rear base plastic (3 screws each), and rear base
plastic (5 screws). See Figures 1 & 2.
11-4 Remove rear step (4 screws). See Figure 3.
11-5 Remove black hardware plugs in treadle plastic
covers with a Flathead screwdriver. Remove left and
right cast covers (2 screws each). See Figures 4 & 5.
NOTE: Before removing cast covers, you may need
to loosen the first screw on the upper treadle
plastic cover to get the cast cover off.
11-6 Loosen belts by loosening the front roller adjustment
screws with provided Allen key (4 screws).
11-7 Remove lower hydraulic cylinders from the treadle
frame with 3/16 Allen key (1 screw each side). See
Figure 6.
mechanical service guide
Figure 1:
Figure 2:
Figure 3:
AS LoNG AS THE TREADCLIMBER
®
FITNESS
MACHINE IS PLuGGED INTo A PoWERED ouTLET
AND THE PoWER SWITCH IS oN, THE uNIT IS
RECEIvING PoWER, EvEN IF THE DISPLAY IS
TuRNED oFF. ALWAYS uNPLuG THE PoWER CoRD
FRoM THE ouTLET AND WAIT 5-MINuTES BEFoRE
PERFoRMING REPAIRS oR MAINTENANCE.
7! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .