11
5. Disconnect the Speed Sensor Cable from the Speed Sensor.
6. Using a #2 Phillips screwdriver, remove the 5 screws from the Right Side Cover
and remove it.
7. Using a 6 mm hex wrench, remove the indicated bolt from the Flywheel.
Note:
Push down and hold the Walking Belt still when removing the bolt. Be sure
to observe the Speed Sensor Magnet orientation on the Flywheel Assembly for
re-assembly.
8. Adjust the Treadles until they are at the same height, and place a static object
(like a book or box) under the Treadles to support them.
The Treadle will fall abruptly if not supported. Keep hands away from the
inside of the Treadles to avoid possible serious injury.
Speed Sensor Cable
Speed Sensor
Speed Sensor
Back of Speed Sensor
Magnet