6
STEP-BY-STEP
GUIDE
0800 003 006
/
boundaryline.co.nz
POST
INSTALLATION
If you are installaing a Boundaryline Wall within 1.5 Kilometers from the seaside we reccomend to apply a bitumen
sealer to the post. The area to apply the bitumen coating to will be 100mm above the concrete line and 100mm
below where the concrete will finish on the post. Most hardware stores will stock a bitumen coating.
This will then cover the 10 years warranty, otherwise Boundaryline accepts no responsibilty for any corrosion.
No posts should be set in actual salt water.
STEP 2 –
SCREW POSTS TOGETHER
Place the two halves of the post on a FLAT surface. Align the pre-punched holes in the post exactly (large flange on top)
and clamp both ends together – see picture.
-
Ensure that the large flange is on the outside.
NOTE:
Screw both ends together first
then fasten one screw in the
middle (with supplied Hex head
screws). The remaining screws
can be fixed in any order.
!
IMPORTANT
!
IMPORTANT
COSTAL
AREA’S
