Dari-Kool III-120 Instructions
1
1E-138B
Dari-Kool
®
III-120
Heat Recovery
System
Instructional Content and Purpose
These instructions aim to aid those responsible (outlined under
“Responsibilities”) for installing, operating, maintaining, troubleshooting,
and servicing this product.
Responsibilities
Procedures in these instructions are to be performed according to
applicable codes (state, local, and other) by the person(s) qualified
(licensed, if applicable) to do so—that is:
• Welding must be done by a qualified welder.
• High-voltage AC power wiring must be done by a qualified (licensed)
electrician in compliance with the latest edition of the ANSI/NFPA
Standard 70, National Electrical Code, (USA) or either LVD
2006
/
95/
EC or EMC
2004
/
108
/EC (Europe) and in compliance with
the l
ocal wiring codes as applicable.
• Other installation, major maintenance, and service work must be
done by an authorized BouMatic dealer.
• Product/system checkout and troubleshooting steps are to be
performed by an authorized BouMatic dealer.
• Deviation from these instructions could affect product performance
or create a hazardous situation. Under no circumstances will
BouMatic be responsible for any problems caused in whole or
in part by any deviation from the procedures specified in these
instructions without prior written approval from BouMatic.
• Operation steps may be
performed by the owner/
operator once the dealer
or technician has suc
-
cessfully finished the
product/system checkout.
The owner/operator is
responsible for properly
operating, maintaining,
and monitoring the prod
-
uct/system to ensure that
it works properly.
Close compliance with the
procedures herein is essential for the owner to get maximum benefit
from the product/system.
Disclaimers
No warranties are contained in these instructions. The division of
responsibilities, stated above, is a general reminder of those provisions
in the applicable dealer contract and does not change any agreement
between BouMatic and the dealer. Information in these instructions is
not all-inclusive and cannot cover all unique situations.
I
nstallation Instructions
P.O. Box 8050
Madison, WI, 53708-8050
USA
Telephone: (608) 222-3484
Fax: (608) 222-9314
Remicourt 31, Rue Jules Melotte
B 4350 Remicourt
Belgium
Telephone: +32 (0)19 544 266
Fax: +32 (0)19 545 544
www.boumatic.com
1.
Preparation
If something is missing, contact the BouMatic Customer
Service Department immediately.
1.1
Reviewing Personal Safety Messages
Follow the safety messages below and throughout this
booklet to prevent possible bodily injury. Safety should
be everyone’s primary concern. Note that the owner
is responsible for replacing safety labels should they
become illegible.
Provide positive, lockable disconnects to prevent
unintended application of electrical power to the
equipment. Refer to national regulations for proper lock-
out procedures for equipment service or repair.
- CAUTION —————————–––——————–––––
Failure to properly install the discharge line from the safety relief
valve could result in hot water spraying on a person, causing
burns.
Introduction
The Dari-Kool
®
III-120 is an insulated water storage tank that
is a refrigerant heat recovery device. It provides two high-
temperature water outputs and an electric auxiliary heating
element. An optional water valve is available.
Contents
Reviewing Personal Safety Messages ..........................................................1
Choosing the Location for the Dari-Kool-120 ....................................................2
