33598-6-0115
Page 41
OPTIONAL DECORATIVE GLASS PANELS (DVLL ONLY)
NOTE: THIS NEEDS TO BE DONE BEFORE INSTALLING THE
GLASS MEDIA BEADS.
PLACING THE OPTIONAL DECORATIVE GLASS PANELS
INTO THE DVLL FIREPLACE:
Use the Glass Identification Chart as a dimensions guide for
the glass glass panel parts.
1. Remove front glass and front door assembly. Be sure there
are no glass media beads on the media tray.
2. Carefully unpack the glass panels. Wear gloves to prevent
any accidental cuts and to prevent fingerprints on the glass.
3. Place the two “A” panels through the small tabs and into the
center rear slots in the media tray base.
4. Place the two “B” panels through the small tabs and into the
outer rear slots in the media tray base.
5. Place the three “C” front glass panels through the small tabs
and into the front slots in the media tray base.
6. Install the glass media beads around the media tray to hide
the small tabs that hold the glass. The glass edges will be illu
-
minated from the light below the media tray. See DVLL Glass
Medial Installation Section in the fireplace Installation Instruc
-
tions.
B
A
A
B
C
C
C
GLASS IDENTIFICATION CHART
ITEM
NUMBER
PART
NUMBER
HEIGHT WIDTH QUANTITY
SUPPLIED
A
R11263
3-1/2”
9-7/8”
2
B
R11383
3-1/2”
8-1/8”
2
C
R11261
2-1/2”
9-7/8”
3
Figure 59
