33598-6-0115
Page 32
Finishing The Wall for DF412BL Decorative Front With Inside Fit
The inside fit front allows for finishing over the face of the fireplace and right up to the removable front.
1.
After installing the fireplace, install the front kit.
2.
Locate the two side stone stops. Loosen the top and bottom screws on the inside opening of the fireplace but do not remove them.
See Figure 51.
3.
Slip the side stone stop under the two screws and tighten. Repeat for the other side.
4.
Locate the steel hood stone stop. Loosen the 7 screws under the top edge of the fireplace - do not remove. Slip the hood stone
stop under the 7 screws and tighten while holding back tightly against the top face of the fireplace.
5.
Secure front face of the hood stone stop to upper fireplace face with three screws.
6.
Hang the decorative front on the four rectangle cut-outs on the face of the fireplace.
7.
Finish around the fireplace, you must use only non-combustible material to cover the steel face and non-combustible board on the
fireplace. All non-combustible finishing materials must stop at the side and hood stone stops. Finishing material must not go past
the stone stops or the front will not fit. Stop the finishing material at the bottom of the valve opening so the valve and fans are clear
for service.
FINISHING THE WALL
►
►
▼
◄
55-1/2” x 13-1/2”
(141cm x 343mm)
NON-COMBUSTIBLE BOARD
HOOD
STONE STOPS
SIDE
STONE STOPS
SIDE
STONE STOPS
NON COMBUSTIBLE
BOARD
2” x 24” (5cm x 61cm)
NON COMBUSTIBLE
BOARD
2” x 24” (5cm x 61cm)
Figure 51
◄
◄
STOP THE FINISHING
MATERIAL ON TOP OF
THE HOOD STONE STOPS
STOP THE FINISHING
MATERIAL ON TOP OF
THE SIDE STONE STOPS
STOP THE FINISHING MATERIAL FLUSH
WITH THE BOTTOM OF THE VALVE OPENING
NON COMBUSTIBLE
BOARD
NON COMBUSTIBLE
BOARD
Figure 52
