Boston Whaler CONQUEST 345, Руководство пользователя

Страница: 146 / 206

4-12 345 Conquest
Section 4 • Electrical System
G
Rigging
Your boat has two flexible conduit rigging tubes,
one port and one starboard above the fuel tank and
below the floor to allow the owner to run new wiring
for electronics. There is a pull cord installed through
the tube with the ends bundled and tied at either end
of the tube. The ends are located in the aft bilge and
inside the console where it exits the rigging boot.
There is also a cord located in the starboard frame of
the hardtop which terminates in the console at one
end and the electronics box at the other.
The optional upper station electrical wiring and hoses
are routed through the port and starboard frames (See
figure 4.12.3).
Tie another piece of nylon cord to the current
accessory wiring being run and use that for later runs.
Rigging Tube/Pull
Fig. 4.12.1
STARBOARD RIGGING TUBE
AFT PULL CORD
FORWARD PULL CORD
1
2
3
1
2
3
Starboard tube shown, port tube typical.
Hardtop Rigging
Fig. 4.12.2
ROUTING FOR ELECTRICAL WIRING P&S
1
1
Optional Upper Station Rigging
Fig. 4.12.3
ROUTING FOR STEERING HOSES
ROUTING FOR STEERING HOSE AND
ELECTRICAL WIRING
1
2
1
2
G