Boston Whaler 330 Outrage 2023, Руководство пользователя

Страница: 87 / 189

3-12
330 Outrage
Section 3 • Systems Overview & Operation
R
O
PE
N
CLOSE
Transom Livewell
Fig. 3.12.1
1
2
3
4
5
6
50 GAL. (189 L) LIVEWELL
FLOW CONTROL VALVE
RAW WATER FILL INLET
MID OVERFLOW DRAIN
BOTTOM DRAIN
TO THRU HULL DISCHARGE
INTAKE SEACOCK W/PUMP
Transom Livewell
A 50 gal. (189 L) Full-Fill livewell is located center
line on the transom.
The livewell keeps baitfish alive by circulating fresh
seawater through the tank.
The livewell has two drains to regulate the amount of
water in the unit. You can regulate the water volume
by inserting the second drain plug (supplied) into the
mid overflow drain, thus raising the level of water
to the upper limit. This “Full-Fill” design provides a
stable environment to reduce fatigue on your baitfish
resulting in a more active and longer lasting product.
The bottom drain is used to empty the livewell
of water completely. By utilizing the drain plug
(supplied) between the two overflow drains in the
side of the livewell you can adjust the level of water
in the unit. A drain tube with strainer connects to the
livewell overflow drains and will direct overflow/
excess water to the thru-hull drains.
“Full-Fill” Livewell Operation
Before operating the system make certain the hull
seacock and flow control valve are in the open
position. The hull seacock can be accessed through
the aft cockpit deck hatch. The flow control valve is
located at the raw water fill inlet. The valve lets you
adjust the flow of water into the livewell tank by
rotating the valve to “OPEN” or “CLOSE” (Figure
3.12.1).
• Make sure that the hull seacocks are in the
open position (See fig. 3.11.1).
• Insert a drain plug (supplied) into the mid
overflow drain (See fig. 3.12.1 ) and fill the
livewell completely.
The upper overflow drain will allow the water to rise
to just below the lid before starting to drain.
4
2
1
3
5
6
Maintenance
Maintenance of the livewell system requires periodic
inspection of the raw water intake strainer on the
hull and all fittings and hoses for system integrity to
prevent leaks.
Clean away debris and/or tighten hose connections
as required. The system should be run at least every
other month to keep the pumps impellers in good
condition.
7
7
ATTENTION
The seacock must be in the open position when
livewell is in use. Running the pump dry may
damage to the unit.
Maintaining this water level enhances the stability
of the water in the tank. .
• Fill the livewell(s) by pressing the switches
marked “FWD L/W” or “AFT L/W” on the
helm switch panel.