Section 4 - Electrical System
305 Conquest-Owner’s Manual
39
Ignition Shutdown Switch
The 305 Conquest is equipped with an ignition shut-
down safety switch. It is located on the lower center
section of the console. The ignition shut down safety
switch incorporates a shut-off switch, switch clip, lan-
yard and lanyard clip, which is clipped to the operator.
If an emergency arises where the engine(s) must be shut
down, a pull on the cord to release the clip from the
shut-off will shut down the engine.
This switch is designed to shut the engine(s) off when
the operator of the boat leaves the control station, ei-
ther accidentally by falling into the boat, or by being
ejected overboard. This would most likely occur as a
result of poor operating practices.
This switch only works when properly used.The decision of
whether to use an ignition safety switch or not rests with you,
the owner/operator.
It is advised that you wear your lanyard at all times
while operating the boat. It is for emergency stopping
only. Do not use it to shut off the engine during normal
operation. The lanyard should be long enough to pre-
vent inadvertent activation.
CAUTION
Ignition Shut-down
Switch
IgnitionShut-down
Switch Plate
The decision to use the safety switch is up to you, the
owner/operator.
NOTICE
!
!
Electric Downrigger Receptacles,
(Optional)
The location for mounting of the downrigger base is
important, refer to the wood location diagram for areas
on the gunwales that are specifically designed for with-
standing the stress generated by a downrigger.
There are a variety of downrigger mounting base plates
that can be used, it is important that you consult with
your salesperson to find the mounting base that will
best suit your application.
CAUTION
There are storage cradles designed for holding the
downrigger weights when not in use. Because of the
variety of weights available these cradles are designed
to hold the most common weights used.
NOTICE
!
!
30 Amp/12V
Receptacle/Cover
30 Amp/12V
Plug
Downrigger
Weight Cradle
The 305 Conquest can be fitted with two (2) electrical
receptacles and plugs for powering electric downriggers.
The receptacles are located inside the cockpit on the aft
section of the port and starboard gunwales and are rated
to 30 Amps. The plugs are supplied in the owners packet
when this option is purchased. Push the plug into the
receptacle and turn clockwise to secure the connection.
There is a “Port 12V Power” and Starboard 12V
Power” breaker on the Helm Breaker Panel located
behind the door below the steering wheel. Should there
be any interuption in power, check here first. The re-
ceptacles are protected by a weatherproof cover. There
areas on the gunwales that are designed specifically for
downrigger mounting bases. See your “Wood Location
Diagram” for proper mounting.
Lanyard (The lanyard shown
in this view is shorter than actual,
and is for reference only).
Ignition Shut-down Switch
Clip, (attaches to switch)
Ignition Shut-down
Switch Clip,(attaches to you)
“12V Power”
breaker panel