4-4
150 Montauk
Section 4 • Electrical System
R
The following pages contain electrical harnesses and
schematics pertaining to the electrical system in your
boat. The schematic was generated by technicians in
the Boston Whaler
®
Engineering Department and are
for reference and to be used by service technicians.
Boston Whaler
®
does not recommend that you
attempt to work on the electrical system yourself.
Instead, we suggest that you take your boat to an
authorized Boston Whaler
®
dealer for electrical
service.
Boston Whaler
®
reserves the right to change or
update the electrical system on any model at any
time without notice to the customer and is not
obligated to make any updates to units built prior
to the change. Contact customer service for current
electrical schematics.
Electrical Schematics & Harnesses
Wiring Identification Chart
Boston Whaler
®
adheres to electrical wiring
requirements which meet all the ABYC-11 standards.
The following chart outlines the gauge, color and
function of the wiring used.
BRN/ORN
SUMP PUMP
BRN/RED
BILGE PUMP (UNSWITCHED)
BRN/WHT MACERATOR
GRY
RUNNING LIGHTS
GRY/BLK
ACC 1
GRY/BLU
ACC 2
GRY/GRN
ACC 3
GRY/RED
AFT MAST/ACC 4
GRY/WHT
ALL ROUND/FWD MAST LIGHT
ORN
REFRIGERATOR or CENTER
WIPER
ORN/BLU HORN
ORN/BRN
STARBOARD WIPER PARK
ORN/GRN
STARBOARD WIPER
ORN/RED
PORT WIPER
ORN/VIO
VACUUM PUMP
ORN/WHT
CENTER WIPER
PINK
FUEL SENDER
RED
12V RECEPTACLE
VIO IGNITION
WHT
CO MONITOR/ELECTRIC TRIM
TAB (SWITCHED)
YLW
BLOWER/STEREO MEMORY
YLW/RED START
COLOR
FUNCTION
GRN
GROUNDING MAIN/TOWER &
ALUMINUM FUEL TANKS
GRN GROUNDING
ORN
STARBOARD 30 AMP
RECEPTACLE
RED
MAIN FEEDS/PORT 30 AMP
RECEPTACLE
BRN/BLK
STARBOARD FISHBOX PUMP
BRN/VIO
FORWARD FISHBOX PUMP
BRN/YEL
LIVEWELL PUMP
(HIGH CURRENT)
BRN/BLU
PORT FISHBOX PUMP
RED
+12V MAIN
BLK GROUND
BLK/YEL
STOP CIRCUIT
BLK/WHT
GEN SHUTDOWN
BLU COMPASS
BLU/BLK
DOME LIGHT
BLU/GRN
SPREADER LIGHT
BLU/ORN
LIVEWELL LIGHT
BLU/RED
COURTESY LIGHTS
BLU/VIO
CABIN LIGHTS
BRN
BILGE PUMP (SWITCHED)
BRN/GRY
RAW WATER
BRN/GRN
FRESH WATER
COLOR
FUNCTION
Wire Color Chart for DC and Special Circuit
There is a risk of electrical shock. Always
have a qualified marine electrician install any
system upgrades that are not already installed
on your boat. There are a variety of wiring
configurations up to 36Volts. Incorrect wiring
will adversely affect your trolling motors
performance. Always use the correct circuit
protection and wire gauge when installing an
upgraded trolling motor wiring system.
!
WARNING
Содержание 150 Montauk
