11
bossweld
.com.au
WARNING!
Ensure the machine is turned off and disconnected from the power supply before
performing any of the following operations.
Fitting the Arc and Work Clamp
1.
For the most common applications, plug the
work clamp
connector into the
Negative
terminal. Twist to ensure a
good connection.
2.
Plug the
Electrode holder
connector into the
Positive
terminal. Twist to ensure a good connection.
Grounding and Fitting the Electrode
3.
Connect the work clamp firmly to the work-piece ensuring
that the clamp makes good contact with bare metal.
4.
Take the electrode holder and press the handle to open the
tong. Insert the bare metal rod end of the electrode and
release the handle to clamp the electrode.
Welding Setup
5.
Plug the machine 10Amp input power lead into the wall
socket, ensuring that the power switch on the machine is in
the OFF position.
6.
Turn the power outlet on and turn on the machine on using
the power switch on the rear of the machine
WARNING: Ensure the electrode/electrode holder is not
near the work-piece when switching on the machine.
7.
Select MMA welding mode by pressing the Welding Process
Selection Button until the MMA Welding Process Indicator
Light is illuminated.
8.
Rotate the Current Adjustment Knob (R) to set welding
current. Use the Welding Current Guide on next page.
MACHINE SET UP - STICK WELDING
Electrode
Holder
Work Clamp
MANUAL
SYNERGIC
MMA
VRD
MIG
WELD
MODE
MANUAL VOLTAGE
15V
24V
SYNERGIC VOLTAGE TRIM
-2V
+2V
MIG 150
MANUAL
SYNERGIC
MMA
VRD
MIG
WELD
MODE
AMPERAGE
MIG 30
MMA 101
40
160
MANUAL VOLTAGE
15V
24V
SYNERGIC VOLTAGE TRIM
-2V
+2V
