Bossard 035/E32V, Руководство оператора

Страница: 7 / 27

7
Ensure that the controller’s power is switch is in the ‘off’ position. Connect the 6-pin tool cable to the
screwdriver. The cable has a spring guard at the one end for added protection and durability. Plug this
end of the cable into the tool. The connector is designed to be a tight fit – seat the connector firmly into the
receptacle and tighten the nut securely by hand. Attach the other end of the cable to the controller in the
same manner. Plug the supplied power cable cord from the controller into a suitable, properly grounded
AC receptacle.
Always turn off controller power and wait 3 seconds before connecting or disconnecting the screwdriver
cable. Do not connect/disconnect the screwdriver with the power supply turned on.
3.3 BEFORE YOU TURN ON THE CONTROLLER
Insert the desired screwdriver installation equipment, into the quick change holder of the driver.
For tools with ¼” hex bit holders, insert the desired installation equipment by pushing (or pulling, depen-
ding on the model) the outer sleeve of the bit holder to release the retainer. Insert an appropriate power
installation equipment, release the sleeve and ensure that the installation equipment is properly locked in
place by pulling back and forth on the installation equipment.
Screwdriver end of cable
includes spring guard for
added durability
Push cable connector firmly
into receptacle and secure
retaining nut hand tight.
Do not overtighten.
32VDC 6-pin
035/E/A – 32V /
CESL8-32V
Series Tool
Connector 40VDC 6-pin
035/E/A – 40V /
CESL8-40V
Series Tool
Connector
Make sure that the tool’s start mechanism (lever, trigger, or
push start) is not engaged to prevent the tool from acciden-
tally starting when turning on the controller’s power switch.
Turn the controller’s main power switch on. Select the desi-
red speed (Hi/Lo) of the screwdriver via the speed switch on
the controller.
If you are using a 40V controller (035/E/A/40V) make sure that
the output is set to match the screwdriver. The covered out-
put voltage select switch for this is situated on the back face
of the controller.