Boss Industries Bullet 2, Руководство пользователя по обслуживанию и техническому обслуживанию

Страница: 14 / 49

14 309003
This inspection should be done prior the compressor test.
I. Check all assemblies, clamps, fittings, hose connections, nuts, and bolts to ensure they are properly
tied and secured to the vehicle. This is a very critical area of inspection. The vehicle should not be
moved until this inspection has been completed.
II. Remove all tools, rags, and installation equipment from the area.
III. Check compressor oil level. Check all valves to ensure they are in correct operating position.
IV. Vacuum all areas that have metal or plastic shavings. Wipe all fingerprints off unit and vehicle.
Installation & Operation
6.4 Pre-Start-up Inspection Checks
6.3 Mounting the Compressor
When mounting the compressor care should be taken to ensure that its location does not impede the
operation of other components on the vehicle. For example, if your vehicle is equipped with a crane, you
must make sure the compressor will not interfere with the swing of the crane. In addition, the compressor
should be installed in an area that permits cool ambient air to enter the air filter and the hot air to exhaust
without recirculating into the air filter. A minimum of 10” of exhaust clearance is needed. The compressor
air filter is mounted on the frame. Cool ambient air is drawn in from above the machine. One last
consideration in the mounting should be the routing of hoses. The unit should be secured to the vehicle with
four 3/8 inch grade 8 bolts, washers, and nyloc nuts. The frame mounting holes are shown on page 10.
The compressor weighs 450 lbs. Ensure that you have a sub structure to support at least that weight. Be
sure to follow all National Vehicle Safety Standards.
6.5 Check all fluid levels
Position the unit on a level surface so that proper amount of fluids can be added
.
I. 5 gallons of gasoline.
II. Engine oil level may have to be topped off after test.
III. Check the compressor oil level .
A. Add oil if needed.
B. Additional oil may need to be added after test.
C. Top off oil level to half the sightglass when finished with the test.