5.1.11 Drum and drum cover (with drum bearing)
1) Remove rear panel (5.1.10).
2) Disconnect belt (from motor pulley) to remove belt tension.
3) Remove dryer shaft clip and two T-20 Torx drum cover screws,
then lift cover from dryer. Drum cover holds drum rear bearing, so
drum isn’t supported once drum cover has been removed.
4) If necessary, drum sleeve bearing can be removed from drum
cover by removing four T-20 Torx screws.
5) Pull drum backward (toward you) to clear front drum support
wheels, then lift drum from dryer.
Disconnecting
belt
5.1.12 Gas valve and burner
The gas valve and burner are attached as an assembly, so the same
instruction applies.
Gas
valve
Burner
Burner
G
G
a
a
s
s
v
v
a
a
l
l
v
v
e
e
Drum cover
Drum
shaft
clip
1) Turn off gas supply & unplug power cord.
2) Remove rear panel (5.1.10) and drum cover (5.1.11).
3) If needed for better access, remove drum.
4) Disconnect gas pipe & 90º elbow fitting from gas valve using a
1” open-end wrench.
5) After noting connections, disconnect wires to all parts, including
gas valve, igniter, flame sensor, Hi-limit & NTC. Be careful to
not damage igniter.
702_58300000143767_ara_en_a
Page 21 of 33
