5.1.15 Front bearing shield
1) Remove front panel screws, but don’t remove panel itself (5.1.14).
If necessary for access, remove top panel (5.1.1).
2) Remove door (5.1.7), door hinge (5.1.9.8) and front panel latch
cover (5.1.9.7) to expose all front bearing shield screws.
3) Remove lint screen and door seal.
4) Remove drum (5.1.11).
5) Remove motor (5.1.13). Slide out complete motor cradle with
motor and fan to save time.
6) Remove NTC and Hi-Limit from bottom of front bearing shield and
lamp from top of front bearing shield. Remove mist water hose for
misting dryers.
7) Remove front bearing shield from rear of dryer.
8) If needed, remove drum support wheels.
5.1.16 Moisture sensor
The moisture sensor can be accessed from the front of the dryer by
opening the door. Carefully pry the sensor from the front bearing
shield (to avoid damaging plastic parts) and disconnect the wire
harness.
702_58300000143767_ara_en_a
Page 23 of 33
