Bosch WTG86401UC, Инструкция по использованию и уходу / Руководство по установке

Страница: 32 / 36

32
Water is leaking out. Dryer is not leveled. Level the dryer.
~
Leveling the dryer; Page 15
The heat exchanger seal is dirty. Clean the heat exchanger seal.
~
Cleaning the heat exchanger; Page 29
Drain hose is leaking. Check entire length of drain hose for leaks; replace if
necessary.
Check that hose is clamped on hose barb at back of
the dryer securely.
Program terminates
shortly after starting.
Laundry is not loaded. Load the laundry.
~
Loading the laundry; Page 23
Load too small for selected pro-
gram.
Use time program.
~
Program selection table; Page 26
Loaded laundry is too dry. Check the loaded laundry. If it is dry, open the door,
remove laundry and turn program selector to
Off
.
The door opens by
itself.
The door not closed properly. Close the door until a click is heard.
Creasing. Laundry load exceeded.
Unsuitable program selected. Do not exceed the maximum load for selected pro-
gram. Remove items of laundry immediately after the
end of the program, hang them up and pull into shape.
Turn program selector to
Off
.
~
Program selection table; Page 26
Drying result is not sat-
isfactory (laundry feels
too damp).
Warm laundry may feel more damp
than it really is.
Remove items of laundry immediately after the end of
the program and turn the program selector to
Off
.
The selected program does not suit
the load.
Use another drying program or, in addition, select the
time program.
~
Program selection table; Page 26
Dryness level is not adjusted. Use
Dry Level
to adjust the dryness level.
~
Dry Level; Page 27
Fine layer of limescale on the mois-
ture sensors.
Clean the moisture sensors.
~
Cleaning the moisture sensors; Page 30
Program termination e.g. main
power supply failure, door open or
maximum drying time reached.
See the problem(s) mentioned in this table.
Initial load is too wet. Spin laundry at higher speed in the washing machine,
before drying.
Switch off the dryer, and than turn it on again.
Drying time too long. Lint filter and/or Heat Exchanger is
dirty.
Clean lint filter
~
Cleaning the lint filter; Page 28
and/or Heat Exchanger.
~
Cleaning the heat exchanger; Page 29
Insufficient supply of air.
Air inlet possibly blocked. Ensure that air can circulate.
Do not obstruct the air inlet on the front of the dryer.
Ambient temperature higher than
95
°
F/35
°
C.
Ventilate the room.
Program does not start
Finish in (remaining)
time is displayed.
A delayed starting time has been
selected and activated.
Drying cycle will begin at proper time to complete at
the selected Finish in time.
Program does not start
-
D
symbol lit up.
Childproof look is activated. Deactivate Childproof look.
~
Childproof lock; Page 24
Problem Possible cause(s) Solution(s)