Bosch WTG86401UC, Инструкция по использованию и уходу / Руководство по установке

Страница: 24 / 36

24
▯
If
DR
indicator lights up, check the drain hose and
its connection.
~
Maintenance of drain hose; Page 30
3.
If required, select
Low Heat
by pressing the button.
~
Additional Program Option settings; Page 27
4.
If required, select
Wrinkle Block
by pressing the
button.
~
Additional Program Option settings; Page 27
Tip:
The estimated remaining time will be updated.
Indicator of program sequence
Bosch dryers use an advanced control system with a
moisture sensor continually monitoring the laundry’s
remaining moisture.
The current state of the process and status of the
program is shown by indicator lights (Damp,
=
, Dry,
End).
Childproof lock
You can secure the dryer against inadvertent changing of
the set functions. To do this, activate the childproof lock
after cycle start.
To
Activate/Deactivate
, touch Time Dry and Finish in
buttons at the same time for 3 seconds. In the display
field, you will see the
D
symbol light indicating the
childproof lock is active.
NOTICE:
The childproof lock will remain activated until
the next cycle start even after switching the machine off.
You must deactivate the childproof lock before the next
cycle and, if necessary, activate it again after starting the
cycle.
Selecting a different program
If you have inadvertently started the wrong program, you
can change this as follows:
1.
Touch Start/
Pause
.
2.
Select another program.
3.
Touch
Start
/Pause. The new drying cycle starts from
the beginning.
Cancel program
If required, you can cancel the selected program:
1.
Touch Start/
Pause
.
2.
Rotate the program selector to
Off
.
Program end
End
appears in the display area and the Start/Pause
button indicator lamp is off.
After the program end, rotate the program selector to
Off
.
Removing laundry/switching the
appliance off
1.
Open the door and remove the laundry.
2.
Turn the program selector to the
Off
position.
Appliance is switched off and dryer light goes out.
3.
Clean lint filter.
~
Cleaning the lint filter; Page 28
4.
Close the door.
Tip:
If at the end of the drying cycle the display does not
light, the energy-saving mode is active. To see diplay,
e.g. press any button.
~
Environmentally friendly use of your dryer; Page 7
Signal
For switching the buzzer on and off touch the
Signal
button.
The buzzer indicates program end if it is activated.
Other alarms are not influenced by this option.
You can also change the following settings:
▯
volume for buzzer
▯
volume for button signals
To change these settings always activate adjustment
mode first.
Activate adjustment mode
1.
Select
Cotton Extra Dry
on position 1.
The appliance is on.
2II