Troubleshooting
en
45
Fault
Cause and troubleshooting
The laundry is too
damp.
The ambient temperature is greater than 30 °C.
▶
Ensure that the ambient temperature is lower than
30 °C.
Insufficient air circulation at the appliance's installation
location.
▶
Ventilate the appliance's installation location.
The water pressure is low.
No remedial action possible.
Laundry is not spun sufficiently.
▶
Always select the highest possible spin speed for
the washing programme in question.
Thick and multi-layered fabrics require a longer drying
time.
▶
Set a timed programme for the subsequent drying.
→
Fan noise during the
washing phase.
Process fan is active.
▶
Not a fault – normal operating noise.
The programme dura-
tion changes during
the wash cycle.
The programme operation is optimised electronically.
This may change the programme duration.
▶
Not a fault – no action required.
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
▶
Not a fault – no action required.
Drum jerks after the
programme starts.
This is caused by an internal motor test.
▶
Not a fault – no action required.
Rushing, hissing
noise.
Water is flushed under pressure into the detergent
drawer.
▶
Not a fault – normal operating noise.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Too much detergent/fabric softener in the detergent
drawer.
▶
When dosing liquid detergent and fabric softener,
observe the marking in the detergent drawer and
do not dose above this.
