en
Faults and what to do about them
46
Faults and what to do about them
E:35
alternating with
-10
(Suitable for spe-
cial models)
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
H:95
alternating with
“Ÿš
when programme is
finished
No water detected in drying phase, may get bad drying result.
"Filter in the water supply is blocked" on page 43
H:32
alternating with
“Ÿš
when programme is
finished
The unbalanced load detection system has interrupted the spin cycle because the
laundry is unevenly distributed. Distribute small and large items of laundry evenly in
the drum.
Other displays
Turn the programme selector to
Av (Off)
, wait for five seconds and then switch it
on again. If the display appears again, call customer services.
Faults
Cause/Remedy
Water is leaking from the
appliance.
■
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
The door cannot be
opened.
■
~~~
(Rinse hold = no final drain) is activated (depending on the
model). Continue the programme by selecting
Spin/Drain
and pressing
A
(Start/Reload/Pause)
.
■
The temperature in drum is too high to open the door.
■
The safety function is activated. Stop the programme?
■
The water level in drum is too high.
■
Can the door only be opened by the emergency release?
"Emergency release" on page 44
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
■
Programme does not start?
■
Is the tap turned on?
■
Could the filter in the water supply be blocked?
"Filter in the water supply is blocked" on page 43
Note:
If an additional water filter has been installed (depending on the
model), check for contaminants and clean if required
~
separate installa-
tion and cleaning instruction for water filter.
■
Is the supply hose kinked or trapped?
Display
Cause/Remedy
