Bosch WGA244U0AU, Инструкция по эксплуатации и руководство по установке

Страница: 19 / 52

Positioning and connecting
en
19
Notes
■
The mains voltage and voltage
indicated on the appliance (rating
plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
■
The appliance is only connected to
an alternating current via a properly
installed earthed socket.
■
The mains plug fits the socket.
■
The earthing system is properly
installed.
■
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
■
No multiple plugs/couplings or
extension cables are used.
■
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used:
z
.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum Clean
Û
programme the first
time
without
laundry.
Note:
■
The appliance must have been
installed and connected properly.
~
"Positioning and connecting"
on page 12
■
Never switch on a damaged
appliance.
1.
Insert mains plug.
2.
Turn the water tap on.
3.
Close the door. Do not load any
laundry.
4.
Run two cycles of
Cottons
i
90 °C
programme.
5.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
dispenser II.
7.
Add standard detergent to dispenser
II according to manufacturer’s
instructions for light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
8.
Close the detergent drawer.
9.
Select
Start/Reload
A
.
10.
When the programme ends, turn the
programme selector to
Off
.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
~
Page 40
3.
Drain any residual water.
~
Page 39
4.
Disconnect the appliance from the
mains.
5.
Remove the hoses.
6.
Empty the dispensers.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.