Bosch WGA244U0AU, Инструкция по эксплуатации и руководство по установке

Страница: 42 / 52

en
Faults and what to do about them
42
Information on the display panel
Display Cause/Remedy
Õ
■
Flashes fast + signal : The door was opened and the water level is too high.
Close the door, continue the programme with Start/Reload
A
button or
select
[
Drain .
■
Flashes slowly : The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
r
■
Flashes (no water supply): Water tap turned on? Filter in the water supply is
blocked?
~
"Filter in the water supply is blocked" on page 40
If an additional water filter has been installed (depending on the model), check
for contaminants and clean if required
~
separate installation and cleaning
instruction for water filter.
Is the supply hose kinked or trapped?
■
Lights up (low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E
lights up The childproof lock is activated – deactivate it.
The symbol
Û
flashes
Run the
Drum Clean
Û
programme to clean and care for the drum and the outer
tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
■
Switching the drum care information signal on/off.
~
Page 36
E:36
alternating with
-10
■
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
drain hose.
■
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
and the water drain hose are not kinked or trapped.
■
The drain pump is blocked.
~
"Drain pump is blocked" on page 39
■
The drain hose at the siphon is blocked.
~
"The drain hose at the siphon is blocked" on page 40
■
The water drain hose is connected too high. Install the water drain hose at a
maximum height of 1 meter.
~
"Hose and cable lengths" on page 15
E:35
alternating with
-10 (Suitable for spe-
cial models)
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
Other displays Turn the programme selector to
Off
, wait for five seconds and then switch it on
again. If the display appears again, call customer services.