English |
17
Bosch Power Tools
1 619 929 K74 | (27.2.12)
Assembly
Battery Charging (see figure A)
Note:
The battery is supplied partially charged. To ensure full capacity of
the battery, completely charge the battery in the battery charger before
using your power tool for the first time.
The cordless worklight cannot be used during the charging procedure; it
is not defective, when it does not function during the charging procedure.
The Lithium-Ion battery can be charged at any time without reducing its
service life. Interrupting the charging procedure does not damage the bat-
tery.
The lithium ion battery is protected against deep discharging by the “Elec-
tronic Cell Protection (ECP)”. When the battery is empty, the cordless
worklight is switched off by means of a protective circuit.
f
Do not continue to press the On/Off switch after the cordless
worklight has been automatically switched off.
The battery can be
damaged.
When the battery charge-control indicator
3
lights up
red
, the battery ca-
pacity is below 30 % and the battery should be charged.
Insert the plug connector
7
of the charger into socket
4
on the side of the
cordless worklight.
f
Observe the mains voltage!
The voltage of the power supply must cor-
respond with the data given on the nameplate of the battery charger.
Battery chargers marked with 230 V can also be operated with 220 V.
Battery Charger
Article number
– EU
– UK
2 609 004 820
2 609 004 822
Output voltage
V=
5.0
Charging current
mA
400
Allowable charging temperature range
°C
0–45
Charging time
h
4.0
Number of battery cells
1
Weight according to EPTA-Procedure 01/2003
g
66
Protection class
/
II
OBJ_BUCH-1229-005.book Page 17 Monday, February 27, 2012 10:31 AM