en
Faults and what to do about them
42
Information on the display panel
Display
Cause/Remedy
Õ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
A
button or select
Spin
.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
r
■
Flashes
(no water supply): Tap turned on? Filter in the water supply is
blocked?
"Filter in the water supply is blocked" on page 40
Is the supply hose kinked or trapped?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:36
alternating with
-10
and
End
when programme is
finished
■
The drain pump is blocked.
"Drain pump is blocked" on page 39
■
The drain hose at the siphon is blocked.
"The drain hose at the siphon is blocked" on page 40
E:35
alternating with
-10
and
End
when programme is
finished (Suitable for
special models)
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
E
(3
寤
)
lights up
The childproof lock is activated – deactivate it.
Å
lights up
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
The symbol
Û
flashes
Run the
Drum Clean 60°C
programme to clean and care for the drum and the
outer tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
■
Switching the information signal on/off.
"Switching the drum-care information signal on/off" on page 37
Other displays
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer services.
Содержание WAU28540TC
Страница 47: ...6 ...