Faults and what to do about them.
en
35
Wait until the drum has stopped turning.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
1.
Switch off the appliance. Disconnect
the mains plug.
2.
Drain the detergent solution
.
3.
Pull the emergency release
downwards with a tool and release.
The washing machine door can then
be opened.
Information on the display panel
Symbol
Cause/remedy
Õ
has lit up
The loading door is locked:
■
while the programme is running,
■
when the programme is paused. It is not possible to add more laundry.
– Temperature too high. Wait until the temperature drops.
– The water level is too high. Close the door immediately, if necessary.
Press the Start button to continue the programme.
Õ
is flashing
■
The door is not properly closed:
– Push the door closed or open and close it again.
– Laundry is caught. Open and close the door again.
– If necessary, switch the appliance off and on again; select a programme,
configure the settings and start the programme.
■
when the programme is paused. The door is open and the water level is too
high. Close the door immediately. Press the Start button to continue the pro-
gramme.
r
has lit up
■
Turn on the cold water tap fully.
■
The supply hose is kinked/jammed. Correct the position of the hose.
■
The water pressure is too low. Clean the filter.
~
Page 34
E
The childproof lock is activated – deactivate it.
Å
has lit up
Too much foam has been detected and additional rinse cycles have been acti-
vated. Add less detergent to the next wash cycle with the same load.
~
Page 28
:
the "Ready in" time is
flashing
The mains voltage is too low.
.
the "Ready in" time is
flashing
Undervoltage during the wash programme.
The length of the programme will be extended.
~
Page 30
