Bosch VJD-3000, Руководство по установке

Страница: 24 / 34

Malfunction Possible causes Recommended solution
No alarm response specified. Specify the desired alarm
response, change the IP
address, if necessary.
Control of cameras or
other units is not
possible. The cable connection between
the serial interface and the
connected unit is not correct. Check all cable connections
and ensure all plugs are
properly fitted.
The interface parameters do
not match those of the other
unit connected. Make sure that the settings of
all units involved are
compatible.
The unit is not
operational after a
firmware upload. Power failure during
programming by firmware file. Have the unit checked by
Customer Service and replace
it, if necessary.
Incorrect firmware file. Enter the IP address of the unit
followed by /main.htm in your
Web browser and repeat the
upload.
Placeholder with a red
cross instead of the
ActiveX components. JVM not installed on your
computer or not activated. Install Oracle JVM from the
Bosch product catalog on the
Internet.
Web browser contains
empty fields. Active proxy server in network. Create a rule in the local
computer's proxy settings to
exclude local IP addresses.
If a sender is connected
to the decoder, the first
connection remains. Auto-connect configured. Deactivate auto-connect.
LEDs
The unit has LEDs on its rear panel that show the operating status and can give indications of
possible malfunctions:
LINK LED
Lights up green: Network connection established.
CONNECT LED
Does not light up: The unit is switched off.
Lights up green: The unit is switched on and startup completed.
Lights up red: Startup in progress.
Flashes green: Data packet transmission via network.
Flashes red: The unit is faulty, for example following failed firmware
upload.
DISPLAY LED
Flashes green: Both analog and digital video can be connected.
Lights up green: Only digital video available.
7.3
24 en | Troubleshooting VIDEOJET decoder 3000
2013.08 | V3 | F.01U.281.923 Installation Manual Bosch Sicherheitssysteme GmbH