Bosch VJC-7000-90, Руководство по установке

Страница: 20 / 58

20 en | Installation Videojet connect 7000
2019-08 | 1.7 | F.01U.291.524 Installation Manual Bosch Security Systems
5.2 Conduit Installation
4. Install cable feed-throughs .
– Based on your installation requirements, install conduit (not supplied), cable glands with
O-rings, and/or plugs into the enclosure holes as needed, using the recommendations in
the graphic below.
Figure 5.2: Layout of VIDEOJET connect 7000 enclosure
1 Optional hole (size M16 / ½), plugged, for cable gland intended for connections to washer*
2 Optional hole (size M25 / ¾”), plugged, for conduit (user-supplied) to AC mains power
3 Cable gland, size M16 / ½, for cable (user-supplied) to AC mains power
4 Optional hole (size M25 / ¾”), plugged, for conduit (user-supplied) for audio* and/or for alarm inputs/
outputs*, or for fiber optic cable (user-supplied)
5 Optional hole (size M16 / ½), plugged, for conduit (user-supplied) for audio* and/or for alarm inputs/
outputs*, or for fiber optic cable (user-supplied)
6 Cable gland, size M16 / ½, for data-only IP cable (Cat5e/Cat6e, user-supplied) or for fiber optic cable
(user-supplied)
7 Optional hole (size M16 / ½), plugged, for conduit (user-supplied) for data-only IP cable (Cat5e/Cat6e,
user-supplied) or fiber optic cable (user-supplied)
8 Optional hole (size M25 / ¾”), plugged, for conduit (user-supplied) for HPoE Ethernet (network) cable
(Cat5e/Cat6e, user-supplied) to IP camera
* Note : This feature is valid only for a MIC7000 camera "bound" to Camera 1.
– Secure the conduit as recommended by the conduit manufacturer.
Note: Use the figure of the layout of the Printed Circuit Board Assembly (PCBA) on the next
page as reference when completing steps 5 – 13.