Bosch UPH Series, Руководство по эксплуатации

Страница: 15 / 82

Installing the Camera/Lens
This chapter outlines the procedures needed to install the camera/lens inside the UPH
housing.
!
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
Electrical Code
®
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
and all applicable local codes. Bosch Security Systems, Inc. accepts no liability for any
damages or losses caused by incorrect or improper installation.
Note: For models that already have the camera/lens installed, go to Installing the High Speed
Positioning System, page 20.
Notice!
This product must only be used with a UL-marked camera, rated 6-12 VDC with a maximum
power consumption of 5 W and a flammability class V-0 and Product Category NWGQ2,8.
Installing the Camera/Lens Mounting Tray
For some models of the High Speed Positioning System, the customer is responsible for
installing the camera and lenses.
To install the camera, follow these steps:
1.
Open the housing by loosening the captive screws on the side and swivel the upper body
until it is completely open (do not remove screws completely).
Figure 4.1: Loosen Screws and Open Lid of Housing
2. Remove the camera/lens mounting tray from the packing box.
3. Install the camera/lens mounting tray attached in the correct position inside the housing
at the location shown below.
4
4.1
High-Speed Positioning System
(HSPS)
Installing the Camera/Lens | en 15
Bosch Security Systems, Inc. Operation Manual 2013.11 | 5.2 | F.01U.291.981