Bosch TCA 58 series, Руководство оператора

Страница: 18 / 108

14
Robert Bosch Hausgeräte GmbH
en
7 Steam generation button
h
Button
h
generates steam for foaming or
warming.
8 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to
g
or
h
. To dispense
steam, the button
h
must be pressed first
(see “Preparing milk froth and hot milk“).
Settings and displays
Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4. You can check the water
hardness using the enclosed test strip or by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1
2
3
4
1­7
8­15
16­23
24­30
1­13
14­27
28­42
43­54
● Determine the water hardness with the
enclosed test strip.
e.g.= Hardness 2
● Switch the device to stand­by.
● Hold down the steam button
h
for at
least 5 seconds. The number of service
buttons
4
,
5
,
a
,
h
that light up indicate
the selected water hardness.
● Press the steam button
h
repeatedly
until the correct number of buttons is lit.
● Press button
a
once. The selected
number of service buttons should light
up briefly; this indicates that the desired
water hardness setting has been saved
successfully.
If a water filter (special accessory) is used,
the water hardness should be set to 1.
P
on Fill water tank 13 , hold cup
+
J
flashing under foaming nozzle 9 and
turn dial 8 to
g
/
h
.
J
flashing Turn dial 8 to
g
/
h
.
J
on Turn dial 8 to
●
.
I
on Empty trays
I
flashing Trays missing
4 Coffee dispensing button
4
Coffee can be brewed by pressing this
button.
Press once for one cup. The coffee is
ground, brewed and dispensed into the cup.
Button
4
flashes during this process.
Press twice within 3 seconds for two
cups. The coffee is ground, brewed and
dispensed into the cups (the grinding
and brewing process takes place twice).
Button
4
flashes and
6
(2 cups) appears
on the display during this process.
i
If the coffee dispensing button
4
is
pressed again, the coffee brewing
process is terminated.
5 Coffee strength button
5
This button
5
is used to select the coffee
strength:
5
mild
55
medium
555
strong
The selected setting is shown on the
display.
6 Standby button
a
Button
a
switches on the appliance or
switches it to stand­by mode. When button
a
is pressed, the appliance heats up and
button
a
flashes while the appliance heats
up and is rinsed. When the buttons
4
,
5
,
a
and
h
light up and one, two or three beans
(depending on the setting) appear on the
display, the appliance is ready for operation.
The appliance will not be rinsed if:
– it was still warm when switched on, or
– coffee was not discharged before it was
switched to “stand­by“ mode.