Bosch TCA 58 series, Руководство оператора

Страница: 22 / 108

18
Robert Bosch Hausgeräte GmbH
en

!
Risk of scalding
When the dial is set to
g
/
h
the nozzle
may sputter a little. Escaping steam is very
hot.
Do not touch the foaming nozzle
9
or
aim it at anyone.
Allow about 1 cup of water to run through.
End the process by turning the dial 8
back to
●
.
Dismantle the foaming nozzle 9 to clean it
thoroughly ( Fig. D ).
Clean with a caustic cleaning solution and a
soft brush. Rinse and dry all parts
Brewing unit
The brewing unit can be removed for
cleaning (Fig. E) .
● Turn off the appliance with button
a
.
● Turn the power on/off switch
1
to
0
.
● Open the door 18 to the brewing unit 19 .
● Hold the red button 19a down and push
the handle 19b up until you hear it
engage.
● Grasp the brewing unit 19 by the handle,
remove carefully, and rinse under running
water. Do not use cleaning agents. Do not
place in the dishwasher.
● Vacuum the inside of the appliance, or
clean it with a damp cloth.
● Reinsert the brewing unit
19
all the way
into the appliance.
● Hold the red button 19a down and push
the handle 19b down as far as it goes,
until you hear it engage. The brewing unit
is now secure.
● Close the doors of the brewing unit.
●
●
Service programme:
Combined cleaning and
descaling process
If an “
S
“ is shown on the display while the
appliance is on, the service programme
must be run immediately to clean and
descale the appliance. If the service
programme is not run as instructed, the
appliance may be damaged.
Specially­developed descaling
(order no. 310967) and cleaning agents
(order no. 310575) are included with the
appliance and can also be obtained from
customer service.
Warning
Each time you run the service programme,
you should follow the instructions for
using the cleaning and descaling agents
carefully.
Never interrupt the descaling programme.
Do not drink the liquids.
Never use vinegar or vinegar-based
products.
Never put descaling tablets or other
descaling materials into the duct for
cleaning tablets.
i
The “
S
“ symbol flashes while the service
programme is running (approx. 40
minutes).
Important: If there is a filter in the water
tank, it needs to be removed before the
service programme is run.
Starting the service programme
Important: There should be approx. 0.5
liters of water in water tank 13 .
● Switch the appliance to stand­by mode
using the
a
button.
● Hold down the coffee dispensing button
4
for at least 5 seconds. The appliance
rinses 2 x through the coffee outlet 10 .