16
EN
Problem
Possible cause
Solution
Appliance not working;
no symbols light up.
There is no power supply.
Check that the appliance is
properly plugged into the
power supply.
I cannot read the LC
display because it is in
the wrong language.
You may want to change the
language setting.
Please proceed as described
in the section “Controls and
displays”.
Machine brews but no
drink dispensed.
The water tank was removed
during the brewing process or
there is air in the system.
Replace the water tank in the
appropriate position in your
TASSIMO PROFESSIONAL
machine. Start a cleaning
process with the Service
T DISC.
The loat in the water tank is
stuck.
Clean the water tank and
ensure the loat can move.
O
Automatic mode
not working, appliance
remains in stand-by
mode.
No T DISC inserted.
Check if T DISC has been
inserted.
The barcode could not be
detected.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact
TASSIMO PROFESSIONAL at
1-888-MYT-DISC.
Troubleshooting
The following table provides solutions for problems and glitches
that may arise as you use your TASSIMO PROFESSIONAL
machine. If you do not ind a solution for your speciic problem,
or the problem persists after troubleshooting please contact
TASSIMO PROFESSIONAL Customer Service at 1-888-MYT-
DISC
.
!
Note:
If piercing unit is missing, it may be purchased
from TASSIMO PROFESSIONAL at 1-888-MYT-DISC or only
in the USA on www.tassimopro.com.
More Customer Service information is available online at www.tassimopro.com
TAS6512CUL_090805.indd 16
11.08.2009 14:27:16