Bosch SGS 45N68, Руководство по эксплуатации

Страница: 9 / 28

en
9
As soon as the rinse-aid refill
indicator
X
is lit on the fascia, there
is still a rinse-aid reserve of 1–2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness
is over 21° dH, rinse aid must be used.
–
Open the cover on the rinse-aid
dispenser
9"
. To do this, press
the mark (1) on the cover
and simultaneously lift
the cover on the control plate (2).
– Carefully pour in the rinse aid to just
below the edge of the filler opening.
– Close cover until it clicks shut.
– To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with
a cloth.
Setting amount of rinse aid
The rinse aid dispensing rate can be
adjusted steplessly. The clear rinse
controller was set to 4 at the factory.
Do not change the position of the rinse aid
control unless there are streaks (rotate
towards –) or water stains (rotate towards
+) on the utensils.
Switching the rinse aid refill
indicator off or on
If the rinse-aid refill indicator
X
is impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
To change the setting:
– Close the door.
– Hold down programme button
3
and press main switch
(
until
the digital display
8
illuminates.
– Release buttons. On the digital display
8 ‚
is indicated (rinse-aid refill
indicator on).
– By pressing button
3
you can switch
the rinse-aid indicator off
‹
or on
‚
.
– Switch off the main switch
(
;
the chosen setting has now been
stored.
Rinse aid
%
5LQVHDLG
FRQWUROOHU