Bosch SENSORSTEAM TDS12 SERIES, Руководство по эксплуатации

Страница: 12 / 116

12
en
SensorSteam
The “SensorSteam” function automatically switches
off the iron when the handle is no longer gripped,
thus increasing safety and energy saving.
When plugging the iron in, during the fi rst
minute:
• The soleplate (12) heats up to the temperature
corresponding to the selected setting.
• The steam generation is blocked.
• The green lamp (4)
fl ashes.
After the initial 1 minute period:
• “eco” setting is automatically selected.
• The green lamp (4) stops
fl ashing.
• The “ActiveControlAdvanced” indicator lamp (2)
(clear light) goes on and starts fl ashing.
From this moment on, when the handle (1) of the
iron is gripped:
• The “ActiveControlAdvanced” indicator lamp (2)
stops fl ashing.
• The pump starts working and steam is generated
automatically.
If the handle (1) is released:
• Steam generation will stop.
• The “ActiveControlAdvanced” indicator lamp (2) will
fl ash
• The iron shuts off automatically. If the handle is
gripped again, the iron turns on.
If the iron remains plugged in and is not used for
several minutes:
• After the handle (1) is touched, the green light starts
fl ashing.
• Steam generation will not be possible for several
seconds, until the appropriate working temperature
has been reached.
Ironing with steam (4)
The steam control is used to adjust the amount
of steam produced when ironing (see “setting the
steam amount” section).
• Set the steam control to “eco” or “max” position.
• Grip the handle (1).
Important :
• Steam is only available if the temperature control
(14) is set at the steam symbols - between
“••” and “max”.
• Adjust the temperature setting and then set the
steam control according to the table below. Steam
will automatically be produced:
Temperature control (14)
setting
Steam setting
••
eco
••• to “max” max
Note: Once a steam ironing setting has been chosen
using the temperature control (14), steam generation
may be delayed for several seconds until the
appropriate working temperature has been reached.
Ironing without steam (5)
This enables the iron to be used for dry ironing.
• Grip the handle (1) and set the steam control to the
setting.
• The temperature control (14) adjusts the temperature
of the soleplate (12). Set it to the corresponding
position by lining it up with the temperature index
(13) on the iron.
Select an appropriate temperature for the type of
material being ironed (see “setting the temperature”
section).
Spray (6)
This can be used to remove stubborn wrinkles.
• Do not use the spray function with silk as staining
may occur.
• When ironing, press the spray button (6) and water
will spray out of the spray nozzle (9) onto the
garment.
Shot of steam (7)
This can be used to remove stubborn wrinkles or
to press in a sharp crease or pleat. It cannot be
used on a synthetic setting for delicate items.
• Set the temperature control (14) to the “•••” or “max”
position.
• Set the steam control to the “max” position.
• Press the shot of steam button (5) on the handle
repeatedly at intervals of 5 seconds.
V