Bosch Rexroth VT-HNC100 3X Series, Руководство по эксплуатации

Страница: 7 / 48

RE 30139-B/12.14 | VT-HNC100...X Bosch Rexroth AG 7/ 48
Safety instructions
2 Safety instructions
2.1 General information on this chapter
The VT-HNC100...3X axis control has been manufactured according to the
accepted rules of current technology. However, there is still the risk of injury and
damage to property if you do not observe this chapter and the safety instructions
in this documentation.
f
Read these instructions completely and thoroughly before working with the
product.
f
Keep this documentation in a location where it is accessible to all users at all
times.
f
Always include the required documentation when you pass the
VT-HNC100...3X on to third parties.
f
Only operate the VT-HNC100...3X in a technically immaculate condition
and as intended, in a safety- and risk-conscious manner, considering these
instructions.
f
In case of failures impairing the safety and modifications to the operating
behavior, shut down the VT-HNC100...3X immediately and report the failures
to the responsible personnel.
2.2 Intended use
The VT-HNC100...3X is an electric assembly.
You may use the product as follows:
A VT-HNC100...3X is intended exclusively for integration into a machine or
system or to be assembled with other components to form a machine or system.
The product may be commissioned only if it is integrated in the machine/system
for which it is designed. Observe the operating conditions and performance limits
specified in the technical data.
The VT-HNC100...3X is used for the open-loop and closed-loop control of
position, pressure, velocity, differential pressure and optional synchronous
operation of maximal four electro-hydraulic axes. When using the unit, you
moreover need superordinate control logics with corresponding I/O components
that in connection with the VT-HNC100...3X are responsible for the holistic control
of the machine's motion sequence and also its monitoring as regards safety.
The VT-HNC100...3X must not be used in explosive environments.
The VT-HNC100...3X is designed for professional and not for private use.
Intended use includes having read and understood this documentation, especially
the chapter 2 “Safety instructions”.
Any use deviating from the intended use is not intended and thus not admissible.
Bosch Rexroth AG does not assume any liability for damages caused by not
intended use. The user assumes all risks involved with not intended use.
Not intended us of the product includes:
• Using the digital axis control outside the specified performance limits and
operating conditions and in particular the specified environmental conditions;
• Using the digital axis control as safety-related part of controls in the sense of
DIN EN ISO 13849. Functional safety must be implemented using appropriate
additional components.