Bosch Rexroth IndraControl VPP 21.2, Руководство по планированию проекта

Страница: 36 / 75

Fig.6-6: Key blocks with key mouse, cursor and special keys
6.2.8 Key Mouse
The key mouse is activated (LED on) or deactivated (LED off) by the key labeled
with the mouse icon. The two keys above this key represent the left and the
right mouse key. The mouse pointer is moved by the four cursor keys.
If the key mouse is active, this keys are not available as cursor keys.
If while booting the PC an external mouse is connected, it is automatically rec‐
ognized and the key mouse is switched off. In this case, the key mouse cannot
be activated, even if the external mouse is disconnected. Only after booting
again the key mouse is reactivated.
6.2.9 Labeling the Front Panel
The four function keys F9 to F12 and the twelve keys of the three key blocks
"Operation" can be individually labeled by .
Two slide-in strips are delivered with the VPP 21. The slide-in strips consist of
plastic or laminated paper. Their height is 12 mm and their length is approxi‐
mately 240 mm. The visible cut-out height for labeling is maximum 7 mm.
The slide-in openings for this strips are hidden by the left handle bar.
To insert the slide-in strips labeled according to your individual requirements,
proceed as follows:
1.
Switch off the VPP 21.
2. Remove the four screws that retain the handle bar and are accessible from
the rear side of the housing.
3. Remove the handle bar in your direction.
4. Insert the slide-in strips from the left into the now accessible slide-in open‐
ings.
Fig.6-7: Two openings for slide-in strips
Project Planning Manual | Rexroth IndraControl VPP 21.2 Electric Drives
and Controls
| Bosch Rexroth AG 29/65
Display and Operating Components