RE 50170-B/10.08 | Type HAB..-4X
Bosch Rexroth AG
21/
32
Installation
Lift the bladder-type accumulator by means of appropriate lifting gear.
f
Put the bladder-type accumulator on the console. The accumulator must be
f
secured in the vertical position by means of the lifting gear.
Make sure that the accumulator is fixed in a vertical way.
f
Fasten the mounting clamps at the right positions.
f
Remove the lifting gear.
f
Risk of poisoning and injuries due to leaking hydraulic fluid!
The contact with hydraulic fluids leads to health hazards (e.g. eye injuries, skin
lesions, poisoning during inhalation).
Slipping may lead to severe injuries.
When covers are removed, unpressurized
residual oil may leak.
Immediately wipe off any leaking oil.
f
Prior to putting into operation the accumulator, check the lines for wear and
f
tear as well as for any damage.
Wear protective gloves, safety goggles and appropriate work clothes.
f
Immediately consult a doctor, when hydraulic fluid comes into contact with
f
your eyes or penetrates your skin.
Remove the cover cap from the oil port of the bladder-type accumulator.
f
Connect the hydraulic lines to the oil port of the bladder-type accumulator by
f
exerting counter-pressure with an open-end wrench on the oil valve.
Tighten the hydraulic lines by exerting counterpressure with an open-end
f
wrench on the oil valve until they fit tightly.
The bladder-type accumulator is now mounted.
The horizontal installation of the bladder-type accumulator comprises the
following work steps:
Fasten the holding device of the bladder-type accumulator at the right positions.
f
Crush injuries and fractures!
Falling or rolling bladder-type accumulators may lead to severe injuries.
Use appropriate lifting gear for the lifting of the bladder-type accumulator.
f
Secure the bladder-type accumulator against unintended rolling.
f
Put two appropriate transport belts around the bladder-type accumulator so
f
that they do not run over accessories (e.g. valves), and that the bladder-type
accumulator is not suspended by the accessory devices.
Lift the bladder-type accumulator by means of appropriate lifting gear.
f
Make sure that the bladder-type accumulator is in an exactly horizontal position.
f
Fasten the mounting clamps at the right positions.
f
Remove the lifting gear.
f
WARNING!
Installation of the bladder-type
accumulator in a horizontal position
CAUTION!
