English– 13
1 609 929 J60 • (05.12) PS
Bevel Angle 45° (Vertical)
Place the power tool in the working position.
Rotate the saw table
14
to the detent
13
for 0°.
Loosen the locking knob
26
.
Swing the tool arm with the handle
2
until the tool arm
rests on the stop bolt
18
.
Checking:
(see Figure
)
Set the combination square to 45° and place it on the
saw table
14
. The leg of the square must be flush with
the saw blade over its entire length.
Adjusting:
(see Figure
)
Loosen the locking nut of the stop bolt
18
with a com6
mercially available ring or open6ended spanner
(10 mm).Turn the stop bolt either in or out until the leg
of the square is flush with the saw blade over its entire
length.
Retighten the locking knob
26
. Then retighten the
locking nut of the stop screw
18
.
In case the angle indicator
50
is not in alignment with
the 45° mark on the scale
58
, recheck first the 0° ad6
justment of the bevel angle and the angle indicator.
Then repeat the adjustment of the 45° bevel angle.
Fence
Place the power tool in the transport position.
Rotate the saw table
14
to the detent
13
for 0°.
Checking:
(see Figure
)
Set the combination square to 90° and place it on the
saw table
14
. The square must be flush with the fence
7
and the saw blade
21
over the entire length of both
legs.
Adjusting:
(see Figure
)
Loosen all four socket6head screws
28
with the Allen
key
29
(6 mm) provided. Rotate the fence
7
until the
square is flush with the fence over its entire length.
Retighten the socket6head screws.
Angle Indicator (Horizontal)
(see Figure
)
Place the power tool in the working position.
Rotate the saw table
14
to the detent
13
for 0°.
Checking:
The middle line of the angle indicator
49
must be in line
with the 0° mark of the scale
10
.
Adjusting:
Loosen the screw
60
with a commercially available
Phillips screwdriver and align the middle line of the an6
gle indicator along the 0° mark.
Storage and Transport
Before all work on the machine, pull the mains
plug.
Storing the Power Tool
(see Figure
)
When the power tool is not in used for a longer time,
protect it against dust by covering with the protective
dust cover
61
provided.
Carrying the Power Tool
Place the power tool in the transport position.
Remove the extension hoops.
Carry the power tool with the right hand by the trans6
port handle
22
and with the left hand on the housing
under the drillings
16
.
Use only the transport devices for transporting the
power tool and never the protective hood or the
swinging guard.
V1
V2
W1
W2
X
Y
PCM10_WEU.book Seite 13 Donnerstag, 1. Dezember 2005 9:16 09
