English– 6
1 609 929 J60 • (05.12) PS
3
FUNCTION
While reading the operating instructions,
refer to the corresponding illustrations of
the power tool on the front pages.
Intended Use
The power tool is intended as a stationary machine for
making straight lengthways and crossways cuts in
wood. Horizontal mitre angles of 645° to +45° as well
as vertical bevel angles of 0° to 45° are possible.
The performance of the power tool was designed for
sawing hard and soft wood as well as chip and fibre
boards.
Noise/Vibration Information
Measured values are determined according to stand6
ard EN 61 029 procedures.
The A6weighted noise levels of the tool are typically:
Sound pressure level: 91 dB(A)
Sound power level: 104 dB(A)
Measurement uncertainty K = 3 dB
Wear ear protection!
The hand6arm vibration is typically below 2.5 m/s
2
.
Technical Data
Switch6on actions cause brief drops in the mains volt6
age. For unfavourable mains conditions, interference
with other equipment can occur.
For mains impedance of less than 0,363
Ω
, no interfer6
ence can be expected.
Product Elements
The numbering of the machine elements refers to the
illustrations of the power tool on the front pages of the
operating instructions.
1
Release button for the tool arm
2
Handle
3
Protective hood
4
Swinging guard
5
Sliding saw table extension
6
Extension hoop
7
Fence
8
Holes for quick action clamp
9
Table insert
10
Scale for mitre angle (horizontal)
11
Lever for mitre angle adjustment (horizontal)
12
Locking knob for variable mitre angles (horizontal)
13
Detents for standard mitre angles
14
Saw table
15
Mounting holes
16
Holes for extension hoop
17
Stop bolt for 0° bevel angle (vertical)
18
Stop bolt for 45° bevel angle (vertical)
19
Roller
20
Dust bag
21
Saw blade
22
Transport handle
23
Cable holder
24
Cover
25
Sawdust ejector
26
Locking knob for variable bevel angle (vertical)
27
Transport locking pin
28
Socket6head screws (6 mm) of the fence
29
Allen key (6 mm) / Phillips screwdriver
30
Battery compartment
31
On/Off switch
32
Switch for the Power Light
33
Switch for laser
34
Allen key (2 mm)
35
Adjustment screw for vertical laser positioning
36
Knurled screw
37
Adjustment screw for horizontal laser positioning
38
Length stop
39
"Extension hoop" attachment set
40
Attachment piece on the housing
Compound Mitre Saw
PCM 10
Order number
3 603 L01 0..
Rated input power
[W]
1 500
Voltage
[V]
230
Frequency
[Hz]
50
No load speed
[min
61
]
4 700
Laser type
650 nm, <1 mW
Laser class
2
Weight
(according to EPTA Proce6
dure 01/2003)
[kg]
13.8
Protection class
/
II
For maximum work piece dimensions,
see the "Working Instructions" Section
Dimensions of Suitable Saw Blades
Saw blade diameter
[mm]
254
Disk thickness of the saw blade
[mm]
1.4 6 2.0
Mounting hole diameter
[mm]
30
PCM10_WEU.book Seite 6 Donnerstag, 1. Dezember 2005 9:16 09
