NetDVR
| User’s Guide | Configuring the NetDVR
20
Bosch Security Systems | 2004-01
Note about time overlap
After the time setting for the NetDVR has been adjusted, there may be an overlap of time
settings of previously recorded images with newly recorded images. To avoid deletion of
images, the frames with the same new time are recorded next to the previous ones. Frames
with the same time settings appear red in the playback bar and playback reverts back to the
time settings again to playback the second set of images with identical time settings.
3.4 Setting Network Information (‘Network’ tab)
3.4.1 Ethernet
The ‘Ethernet’ section of the ‘Network’ tab
allows the IP address, Network Mask, Gateway
address and DNS server addresses to be set
manually.
Note:
There is no field for Broadcast address
configuration because this is configured
automatically. If the addresses are incorrectly
assigned, the NetDVR cannot be accessed.
The DHCP (Dynamic Host Configuration
Protocol) is for the Network administrator to
automatically assign IP addresses to the
connected network devices. It is only used in
combination with the optional WRS feature. If
the administrator checks the ‘DHCP Enable’
option, IP address in the NetDVR is
automatically set; the IP address will not be
shown.
3.4.2 xDSL (PPPoE)
When using a xDSL connection with PPPoE login, check the xDSL box and enter the User
ID and Password needed to login on the Internet account.
3.4.3 DNS
The DNS section of the ‘Network’ tab is used when a NetDVR is registered on the dynamic
IP registration list of a WRS (Web Registration Server). Enter the address of the WRS server
in the DNS fields.
NetDVR.book Page 20 Wednesday, May 12, 2004 4:06 PM
