Bosch NET5466SC, Инструкция по использованию и уходу

Страница: 17 / 40

17
Notes
▯
The cooktop regulates the heating element
temperature by turning the heat source on and off; this
means that the reddish glow of the heat source
beneath the heating element may not always be
visible. If you select a low heat setting, the heat source
is frequently off; at higher settings it is seldom off. The
source turns on and off even at the highest settings.
▯
You may hear a quiet hum when the heating elements
are in the heating phase. The heating elements may
glow with different levels of brightness. Depending on
the angle from which you are looking at the heating
element, this glow may be visible over the marked
edge of the heating element. These are technical
characteristics. They have no effect on quality and
function.
▯
Glass ceramic may have uneven areas on the surface
due to the nature of the material itself. Because of the
mirror-like finish on the cooking surface, even
extremely small bubbles less than 1 mm in diameter
may be visible. These bubbles will not have any
adverse effect on the operation of the cooktop nor on
the durability of the glass ceramic cooking surface.
▯
Depending on the countertop that is present in the
kitchen, an uneven gap between the cooktop unit and
the countertop can occur. For this reason, a flexible
seal is provided around the entire cooktop unit.
Technical service
Contact our Technical Service Department if your
appliance needs repair. Our central Customer Service
Center (see below) will also be happy to supply you with
details on a center close to you.
E number and FD number:
When you contact our service, please have the Model(E)
number and the FD number for your appliance available.
You can find the identification plate with these numbers
on the underside of the appliance and in the appliance
booklet.
Questions? Please contact us. We look forward to
hearing from you!
Ӡ and the heat
setting flash alter-
nately. An audible
signal can be
heard
Warning: There is a hot pot in the
area of the control panel. There is a
risk that the electronics will overheat.
Remove the pot. The fault display goes out shortly after-
wards. You can continue cooking.
Ӡ
and audible
signal
There is a hot pot in the area of the
control panel. To protect the elec-
tronics, the cooking zone has been
switched off.
Remove the pot. Wait a while. Touch any control. When
Ӡ goes out, you can continue cooking.
”‰
The cooking zone was in operation
for too long and has switched itself
off.
You can switch the cooking zone back on again immedi-
ately.
Indicator Error Task
0DLQ6WUHHW6XLWH
,UYLQH&$
ZZZERVFKKRPHFRP