27
en
Troubleshooting
Troubleshooting
Problem
Cause
Remedy
A programme starts as soon as
the appliance is plugged in.
The “Auto-Restart” function
is continuing with an aborted
programme.
X
“Auto-Restart
function” see page 7
Press button
H
to stop the programme
and to enter standby mode.
The prepared meal is half-raw.
Filled beyond capacity.
Do not fill the pan beyond the mark
[ 4.0 litres ]!
The ratio of the amount of water
and the ingredients is incorrect.
Adjust the ratio of the amount of water
and the ingredients.
Foreign objects in the appliance
interior.
Remove all foreign objects. Do not use
any water for this purpose!
The pan is deformed.
Contact customer service.
Fault in the appliance.
Fault in the sensor.
The prepared meal is burnt.
There is dirt underneath the pan. Thoroughly clean the pan and the
appliance interior.
The pan is deformed.
Contact customer service.
Fault in the appliance.
Fault in the sensor.
The appliance boils over.
Filled beyond capacity.
Adjust the amount.
The temperature is too high.
Reduce the temperature.
The selected preparation
programme requires the meal to
be cooked with the lid open.
Open the lid of the appliance.
LED does not light up.
The appliance is switched off.
Switch on the appliance.
Fault in the power cord.
Contact customer service.
The hotplate does not function. Fault in the appliance.
Contact customer service.
The hotplate is damaged.
Water is flowing out of the
appliance.
The appliance features overflow
protection.
The condensation tank is full and
overflowing.
Remove water from condensation
tank. Remove the pan and use a
cloth to rub the appliance interior
dry. Ensure that no water enters the
appliance interior.
The pressure locking handle of
the appliance cannot be opened.
Food is obstructing the
overpressure lock and the
pressure locking handle is
blocked.
Proceed as described in chapter
X
“Release steam manually” see
page 15
. If the problem persists,
contact customer service.
Steam constantly escapes from
the steam outlet, even though
the steam pressure function is
switched on.
The valve plug is not properly
placed on the valve.
Disconnect the appliance from the
power supply and allow to cool down.
Remove the steam outlet and place
the valve plug properly on the valve.
Display screen
P
This is not an error. The steam is
released automatically.
Wait until the steam has been released
completely or release steam manually.
MUC6-8_RU_8001018000.indb 27
07.03.2016 10:38:05